IF you do this modification your memory would slow down, this is a MAJOR drawback, but on the other hand you can run your CPU faster, some people reported that they used 68060RC60A in over 80Mhz.

Also not that this modification is NOT tested by me (yet), and if you try, PLEASE mail me and tell me if it worked (it should.).

1. Remove the card from the machine.

2. Move the jumper beside the oscillator from '060' to '040'

2. Look under the turboboard, about down under the jumper, there it should be a soldered jumper marked 'pad', and connected to 'gnd', modify it so it's connected to the right solderpad instead.

3. Reassemble the machine and test your card.

Tillbaka till Glenn's hemsida.